Binding a Receiver

Step 1: Turn on your controller/transmitter

Step 2: Create a new Model

  1. Go to the menu by pressing the hamburger of 3 horizontal lines on the left-hand side of your controller
  2. Go to an empty line
  3. Press the big circle button on the right-hand side of your controller
  4. Press ‘Create New Model’

Step 3: Bind

  1. Press ‘Page’ → You’ll be on ‘Setup’
  2. Scroll down and find Internal RF
  3. Before doing stuff, check:
    • make sure ‘Mode’ is set to D16
    • Range is set to ‘CH1 - 16’
    • Fail safe is set to ‘No Pulses’
  4. Press [Bnd] to bind. Once it starts chirping, Simultaneously do the following:
    • Hold button on receiver. (There will be a small button on the receiver that might need to be pressed using a screwdriver or something similar).
    • Turn on your bot.
    • You should hear a new chirp that sounds like a Star Trek communicator.